My infection skips at times, i was wonder if transforming the fluid might aid since it has actually never been done. If so exactly how much liquid does it take


You are watching: 2003 ford explorer transmission fluid change

*

It's feasible that the filter and/or liquid is contaminated and needs changed yes. It's a sealed unit though and also requires special procedures for filling. There space no precise capacities because that a service because it is filled utilizing the procedure in the attachments below.I would begin by pumping 3 quarts in to start, might use as much as 6 relying on how lengthy it drained
*

*

*

*

infection problem2003 Ford traveler V8 4 Wheel drive Automatic the dealership tells my brother that he need to drop the tranny in order to replace the liquid is this true and if not just how does he execute it


See more: How To Test A Microwave Diode, How To Replace A Microwave Diode

DRAINING & REFILLINGNOTE:For ideal transmissions, usage the Automatic infection Flush and Fill machine (211-00018) or the Automatic transmission Flush and also Fill device (199-00010) or equivalent.DrainingWith the automobile in Park, place it on a hoist. Collection the automobile as close come level as possible.Remove the drain plug (large plug) and enable the fluid to drain. Check out Fig. 9 .Remove transmission liquid pan screws and also fluid pan. Eliminate transmission liquid pan gasket, filter screws and filter. See Fig. 10 . Remove transmission fluid pan magnet.Fig. 9: Removing/Installing drain Pan, Gasket & FilterCourtesy of FORD engine CO.Fig. 10: identifying Transmission liquid Filter BoltsCourtesy the FORD engine CO.RefillingTo install fluid pan, gasket and filter, reverse removal procedures. Hold the larger drain plug through a wrench and remove the little (center) liquid level denote plug using a 3/16" Allen key. Install the liquid Level & to fill Plug Adapter (307-437) into the pan. View Fig. 4 .

*

Prior to pour it until it is full the fluid Transporter/Evacuator/Injector (307-D465) with clean transmission fluid, make certain that the canister is clean. See Fig. 5 .

*

Fill the special tool through clean automatic transmission fluid. Cave the liquid transporter/evacuator/injector under the vehicle, upright and also close come the transmission.Connect the open finish of the liquid hose from the liquid transporter/evacuator/injector come the fluid level and also fill plug adapter at the bottom that the transmission fluid pan. View Fig. 6 .Apply a best of 30 psi (206.85 kPa) to the open end of the vacuum/pressure hose from the Rubber pointer Air Nozzle (100-D009). Watch Fig. 7 . Liquid will automatically start flowing the end of the distinct tool into the transmission liquid pan.Add 2 or 3 quarts that transmission fluid into the fluid pan. Avoid the procedure by releasing the waiting pressure and removing the air nozzle from the end of the hose. Engine idle rate is around 650 RPM. Start and also run the engine till the transmission liquid temperature is between 80-120 F (27-49 C).Inspect the fluid level in the one-of-a-kind tool. If the liquid drains earlier into the canister, the transmission is full. If no liquid drains back, more fluid will must be added. Repeat actions 6 and also 7 .Once the transmission is full, location a hand vacuum pump top top the open finish of the vacuum/pressure water tap of the Vacuum Pump Kit (416-D002) and apply vacuum to the system. Watch Fig. 8 . This will certainly pull out any kind of extra fluid trapped in the system and direct it right into the container.Allow the liquid to drain. When the liquid comes out as a slim stream or drip, the fluid is at the exactly level. Reinstall the small (center) liquid level indicating plug using a 3/16" Allen key.